Wavetronix SmartSensor Matrix (SS-225) - User Guide Bedienungsanleitung PDF herunterladen (Seite 73)

72 CHAPTER 7  LANES & STOP BARS

Saving the Conﬁguration

Aer automatic and manual conguration is complete, click the Save Cong button to save

the changes to the sensor. If you attempt to leave the Lanes & Stop Bar view before saving

your changes, the following prompt will appear (see Figure 7.8).

Figure 7.8 – Save Changes Dialog

Moving the Sensor View

e SSMM soware shows the position of the SmartSensor Matrix and the view is drawn

from the perspective of the sensor. If the perspective in the soware does not match your

perspective of the roadway, click the Rotate View button until the sensor position matches

the approach you are conguring.

Note

Moving the sensor in the software will have no eect on the sensor’s performance.

Its purpose is to facilitate the conﬁguration process.

Restarting Auto Lane Conﬁg/Rebooting the Sensor

Restarting the automatic lane conguration will erase any auto-conguration information

that may have been gathered and will start the auto-conguration process over again.

Rebooting the sensor will also erase any auto-conguration information, but in addition

will clear and recongure the sensor thresholds.

Follow the steps below to restart the automatic lane conguration process or reboot the

sensor:

1 Click the Restart/Reboot button and the Restart or Reboot window will appear (see

Figure 7.9).

2 Select the appropriate radio button and click OK.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 116 117

Keine Kommentare

Wavetronix SmartSensor Matrix (SS-225) - User Guide Bedienungsanleitung Seite 73