Wavetronix Click 222 (system surge protector) (CLK-222) - Qui Bedienungsanleitung PDF herunterladen

Click 222 System Surge

INSTALLER QUICK-REFERENCE GUIDE

Wire earth ground

All Click 222 devices must be grounded. To ground the device:

1 Connect a grounding wire (14 AWG) from one of the screw terminals marked PE (protective earth) to

a grounded location—for instance, to a lug bolt, if there is one on the cabinet for grounding, or to an

earth ground terminal block.

2 Connect another grounding wire from there to earth ground.

For additional security, ground the DIN rail that the Click 222 is mounted on:

1 Connect the grounding wire from the DIN rail to a grounded location—for instance, if there is a lug

bolt on the cabinet for grounding, or to an earth ground terminal block.

2 Connect another grounding wire from there to earth ground.

www.wavetronix.com

801.734.7200

Mount the device

e Click 222 mounts over a T-bus for power and communication:

1 If the Click 222 was shipped with the T-bus connector attached,

remove the connector from the module.

2 Snap the connector onto the DIN rail by positioning it over the

rail with the male connector pointing to the right. Hook one arm

over the edge of the DIN rail and press down on the other arm

until it snaps into place.

3 Connect the T-bus connector to the rest of the T-bus by sliding

them together until you hear them snap into place.

4 Mount the Click 222 onto the DIN rail: position it properly over

the T-bus connector, hook the lip over the lower edge of the DIN

rail, and use a rocking motion to snap the module into place.

5 If you are using multiple Click 222 devices, follow steps 1–4 to

mount them next to the rst device.

1 2

Click 222 System SurgeINSTALLER QUICK-REFERENCE GUIDE2 Wire earth groundAll Click 222 devices must be grounded. To ground the device:1 Connect a grou

Keine Kommentare

Wavetronix Click 222 (system surge protector) (CLK-222) - Qui Bedienungsanleitung