Wavetronix SMARTSENSOR 105 Bedienungsanleitung PDF herunterladen (Seite 24)



Page 1



RTMS

Installation and Configuration

I. Connect to sensor

a. Connect the RTMS cable to the battery using the positive and negative battery terminals

b. Disconnect cable at the RTMS port that leads from the RTC Utility (Figure 1)

c. Connect RTMS cable from laptop COM port to RTMS data port in the RTC housing unit

(Figure 1)

Figure 1. RTMS COM Port Setup

II. Open the WinRtms program on the laptop

III. Click the Setup Wizard for step-by-step setup

a. Specify RTMS mode of operation

b. Click OK

c. The Wizard will proceed to set sensitivity and initial zone setup

d. Resulting zone setup is presented for approval

e. Visually verify, using vehicle blips, whether zones were placed in all lanes of interest.

¾ If they are, click SKIP

¾ If not, click OK to manually change the number of zones and their location

IV. Click the SENSITIVITY button

a. Use up and down arrows to adjust sensitivity

b. Typical median value is 7

c. Set a value of 5 if only a few close lanes are being monitored

d. Increase sensitivity if needed to detect smaller vehicles in middle lanes of interest

To Laptop

COM Port

1 2 ... 19 20 21 22 23 24 25 26 27

Keine Kommentare

Wavetronix SMARTSENSOR 105 Bedienungsanleitung Seite 24