Wavetronix SmartSensor Matrix (SS-225) - Quick-reference Guid Bedienungsanleitung PDF herunterladen (Seite 3)

Wire power to backplate

Attach the 6-conductor cable and ground the sensor

1 Tear the tab o the silicon dielectric compound and squeeze about 25% of it into the connector at the

base of the sensor. Wipe o any excess compound.

2 Insert the cable into the connector and twist clockwise until you hear it click into place.

3 To avoid undue movement from wind, strap the cable to the pole or run it through a conduit, but leave

a small amount of slack at the top of the cable to reduce strain.

e SmartSensor Matrix provides its own surge protection, so there is

no need for a pole-mount box on the sensor side of the cable. Instead,

the cable should run straight to the main trac cabinet; landing the

cable in the cabinet will be covered later in this document.

It is necessary, however, to ground the sensor:

1 Connect a grounding wire to the grounding lug on the bottom of

the sensor.

2 Connect the other end of the grounding wire to the earth ground for the pole that the sensor is

mounted on. Do not attempt to run the grounding wire back to the main trac cabinet.

Mount the preassembled backplate in the main trac cabinet

e SmartSensor Matrix preassembled backplate must be installed in the main trac cabinet. To do so,

locate the area planned for mounting the backplate; it can usually be mounted on the side panel of a NEMA-

style cabinet. en attach the backplate with the U-channel mounting screws.

Use the following steps to connect power to the AC terminal

block on the bottom DIN rail:

1 Connect a line wire (usually a black wire) to the bottom of

the “L” terminal block.

2 Connect a neutral wire (usually a white wire) to the bottom

side of the “N” terminal block.

3 Connect a ground wire (usually a green wire) to the bottom

of the “G” terminal block.

4 Turn on AC mains power.

5 Press the circuit breaker switch on the le side of the top

DIN rail to switch power to the backplate.

6 Verify power is regulated by seeing that the DC OK LEDs

are illuminated on the Click 201/202/204.

If you’re using a Click 650 with your Matrix, consult the 650 quick reference guide for the rest

of your installation. If you’re using a preassembled backplate, complete the steps below.

Note

1 2 3 4

Keine Kommentare

Wavetronix SmartSensor Matrix (SS-225) - Quick-reference Guid Bedienungsanleitung Seite 3