Wavetronix Command DataView (CMD-DV) - User Guide Bedienungsanleitung PDF herunterladen (Seite 104)

APPENDIX 103

Factor Group Reports

e only node available under Factor Group is Volume.

Volume

e Factor Group > Volume node has two available reports:

 Average Daily Trac Percentage for Factor Group – is report is similar to the Basic

> Volume > Average Daily Trac Percentage report. e dierence is the values in this

report are the averages of all the stations assigned to the same factor group.

Because this report operates on stations in factor groups, the stations you select for the

report must be assigned to factor groups. In addition, this report only operates on per-

manent count stations in the factor group. A station is considered a permanent count

station if the property “Method of Trac Volume Counting” is set to “Permanent au-

tomatic trac recorder (ATR).” If these two conditions are not met, the report will fail.

Figure A.20 – Average Daily Trac Percentage for Factor Group

1 2 ... 99 100 101 102 103 104 105 106

Keine Kommentare

Wavetronix Command DataView (CMD-DV) - User Guide Bedienungsanleitung Seite 104