
CHAPTER 1 INSTALLING THE SMARTSENSOR HD 15
Note
Do not over-tighten the fasteners.
Figure 1.3 – Attaching the Sensor to the Mount Bracket
Aligning the Sensor to the Roadway
Use the following steps to correctly mount and align the SmartSensor HD:
1 Tilt the sensor down so that the front is aimed at the center of the detection area (see
Figure 1.4).
Figure 1.4 – Up-and-down Positioning
2 Adjust the side-to-side angle so that it is as close to perpendicular to the ow of trac
as possible (see Figure 1.5).
Kommentare zu diesen Handbüchern