Wavetronix SmartSensor HD (101-0415) - User Guide Bedienungsanleitung PDF herunterladen (Seite 72)

CHAPTER 7  DATA 71

Note

When NOT using If volume = 0, speed = 0 feature, then if the volume in the interval

is zero, and the occupancy is less than 20%, the speed in the interval will be the speed

of the previous interval. If the volume in the interval is zero, and the occupancy is

more than 20%, the speed in the interval will be zero.

Storage

e Storage window allows you to turn on/o data storage; see a storage timeline, the stor-

age level and the amount of storage space remaining; and clear all storage on the sensor (see

Figure 7.5).

Figure 7.5 – Storage

Use the On/O switch to turn the sensor’s data storage feature on or o. If you check the

Stop when FULL checkbox, the sensor will stop storing data once the storage capacity is

reached, and consequently all new data will not be saved to memory.

e status section shows the date and time that the rst and last interval data packet was

stored and how much storage is remaining by both a status bar and a percentage. e Total

and Remaining elds show how long the sensor has been storing data and how long the sen-

sor will continue to store data before reaching maximum capacity. e capacity is tracked

in months, days, hours, minutes and seconds and is based upon the current sensor congu-

ration. e total number of intervals stored is dependent upon the number of congured

lanes, approaches and bin data types.

If data is stored with a dierent number of lanes, approaches or bin data types from the

current sensor conguration, the Tota l eld will be incorrect. In this case, the green status

bar is a better indicator of storage capacity. Additionally, using a virtual connection will also

cause the information in this screen to be incorrect.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 88 89

Keine Kommentare

Wavetronix SmartSensor HD (101-0415) - User Guide Bedienungsanleitung Seite 72