
CHAPTER 9 DRIVER REFERENCE 109
Note
After you sync the time on the sensor to the time on your PC, interval times on the
sensor may be o by a few seconds. Collector will then automatically change the
interval time back to the normal time. For example, if Collector is expecting a time
of 08:10:30 and it receives a time of 08:10:38, Collector will change the time back to
08:10:30.
Figure 9.2 – SS125 Custom Panel
Custom Fields
Auto Detect GIS Settings – Turns on parsing for the Location eld. Collector will at-
tempt to get the latitude, longitude and route name from the sensor’s location value and
automatically load it into the appropriate elds. e Auto Detect will run every time
the conguration is updated (usually every six hours).
Comm Type – Allows you to choose Network, Serial or Serial Modem as the com-
munication type.
Receive Delay – Allows you to control how many milliseconds Collector waits for re-
sponses to commands. is is to adjust for various network types and devices. Delaying
avoids unnecessary errors/error statuses.
Buer-safe Collection – An option for dealing with limited capacity network devices.
Some devices can’t handle as much data as Collector normally sends/receives, as fast as
Collector sends/receives it. is causes the sensor to send its data in smaller chunks, so
that its on-board memory does not overow.
Diagnostic Logging – Allows you to debug or detect problems with a driver. Collector
will create a text log of commands sent, timing of events and response data from sen-
sors. Contact Wavetronix Technical Services before using this option.
Wavetronix SmartSensor (SS105)
e Wavetronix SmartSensor 105 is an above-ground trac sensor that uses patented Digi-
tal Wave Radar technology to accurately detect vehicle volume, speed and occupancy from
eight lanes of trac simultaneously.
Kommentare zu diesen Handbüchern