Wavetronix Click 510 (communication tester) (CLK-510) - Quick Bedienungsanleitung PDF herunterladen (Seite 3)

Manually set baud rate (optional)

Note. is step is optional because if you prefer not to select the baud rate manually, you can also autobaud

the device (see Part 3).

1 Hold the push-button down, then release when the g 1 reen LED starts ashing.

2 Press the push-button again to select the baud rate task. e LED indicating the current baud rate will

turn on (see table).

3 Hold down the push-button. e yellow LEDs will cycle through the eight possible baud rates, rst by

lighting up solid and then by ashing, as shown in the table below.

1st LED 2nd LED 3rd LED 4th LED

Yellow LEDs solid 1200 bps 2400 bps 4800 bps 9600 bps

Yellow LEDs ﬂashing 19200 bps 38400 bps 57600 bps 115200 bps

4 Once you reach the baud rate you want, release the push-button, then press it once to select.

5 e device will return to the operating mode it was in before you started the baud rate task.

First test mode: Sensor Emulation

Sensor Emulation mode tests connections between a sensor and other devices. e Click 510 can mimic a

SmartSensor 105 and send trac data, allowing you to see if breaks in communication are caused by the

communication channel or by the sensor itself. It also allows you to check the functionality of an assembled

trac cabinet before attaching a sensor. In both these cases, the device should be connected to a contact

closure module such as the Click 100 or 172/174 so the response can be monitored.

1 Hold the push-button down, then release when the blue LED starts ashing.

2 Press the push-button to select. e rst yellow LED will turn on to let you use that submenu.

3 To pick how oen the device will send data, hold down the push-button and it will cycle through the

time options shown in the table below. Release when you reach one you want.

4 Press the push-button to select. e rst red LED will turn on to let you use that submenu.

5 To pick what kind of data the device will send, hold down the push-button and it will cycle through the

trac options shown in the table below. Release when you reach one you want.

6 Press the push-button to select.

1st LED 2nd LED 3rd LED 4th LED

Submenu 1 (Yellow LEDs) 1 second 0.25 – 1 second Switch (when push-

button is pressed)

Submenu 2 (Yellow LEDs) 17'–60' 30–60 mph Random trac Diagnostic trac -

7 Connect the device to a contact closure device, such as a Click 172/174. Set up the contact closure

device (see the pertinent quick-reference guide) and the mode will begin to run. As the mode runs, the

blue LED will ash fast and the submenu LEDs will light up if the Click 510 is pushing data. Monitor

the contact closure device to see if data is received.

1 2 3 4

Keine Kommentare

Wavetronix Click 510 (communication tester) (CLK-510) - Quick Bedienungsanleitung Seite 3