Wavetronix SMARTSENSOR 105 Betriebsanweisung PDF herunterladen (Seite 67)

66 CHAPTER 6  SENSOR SETTINGS

e General tab contains the following elds:

 Serial Number – Contains the sensor serial number and cannot be edited.

 Sensor ID – Contains the ID used to uniquely identify all sensors on a multi-drop bus.

is ID is the last seven digits of the sensor’s serial number and cannot be edited.

 Description – Allows you to enter a description for each sensor. Limited to 64 char-

acters.

 Location – Allows you to enter the intersection location of the sensor. Limited to 64

characters.

 Approach – Allows you to enter information about the direction of trac the sensor is

detecting (e.g. NB, SB, EB, WB). Limited to 32 characters.

 RF Channel – Lets you set which one of the eight radio frequency channels the sensor

is using. Using multiple sensors in close proximity will require each sensor to be set

to a dierent RF channel (see the introduction for more information about mounting

the sensor).

 Sensor Height – e height of the sensor in feet. is value aects the sensor's detec-

tion algorithms. Entering an approximate height measurement for the sensor allows

detections to be placed correctly on the roadway.

 Wash-out Time – Used to set the time the sensor has to see a tracker before it gets

washed out into the background.

 Units – Allows sensor height, zone dimensions and road objects to be viewed in metric

mode rather than standard units.

Comm Sensor Settings

e Comm tab allows you to change the response delay, and other settings (see Figure 6.2).

Figure 6.2 – Comm Tab

 Response Delay – Used to congure how long the sensor will wait before responding

to a message received. is is useful for some communications devices that are unable

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 106 107

Keine Kommentare

Wavetronix SMARTSENSOR 105 Betriebsanweisung Seite 67