Wavetronix SmartSensor 105 (SS-105) - User Guide Bedienungsanleitung PDF herunterladen (Seite 51)

50 CHAPTER 5  SENSOR SETTINGS

Although the information cannot be edited, there must be an active connection to view

the Sensor Information page. e page is divided into two sections, Identication and

Firmware Versions.

e Identication section information includes the following:

 Serial Number – Shows the 16-digit serial number given to the sensor by the manu-

facturer. It can be used to uniquely identify the sensor.

 Description – Shows the 32-character, user-created sensor description as set using the

Sensor Settings screen (for more information, see the Sensor Settings section later in

this chapter). It is used to describe the sensor and/or the installation site.

 Location – Displays the 32-character, user-created location description as set using the

Sensor Settings screen (for more information, see the Sensor Settings section later in

this chapter). It is used to describe the location of the sensor.

 Sensor ID – Shows the 4-digit numeric string used to identify the sensor on a multi-

drop network. You can set this ID number using the Sensor Settings screen (for more

information, see the Sensor Settings section later in this chapter). e SmartSensor

Multi-drop protocol uses the sensor ID to uniquely address sensors on a shared bus.

 Serial Interface – Indicates which of the sensor’s four ports it is using to communicate.

e four ports are RS-232, RS-485, EXP-A, and EXP-B.

Note

The two expansion ports (EXP-A and B) are currently not available for use.

e Firmware Versions section shows on which versions of DSP (Digital Field Processing)

and FPGA (Field Programmable Gain Amplier) the sensor is operating.

Sensor Settings

You can both view and change certain sensor options and information in the Sensor Set-

tings page. To access this page, go to Edit > Sensor Settings. If no sensor connection is

active, selecting this will open a directory box, allowing you to nd SmartSensor congura-

tion (.ssc) les that are saved on your computer. You can also use this directory box to create

a new .ssc le.

e Sensor Settings page is divided into three tabs: General, Communication and Data

Collection. Only the General and Communication tabs will be discussed here; the Data

Collection tab will be discussed in chapter 7.

General Tab

e General tab allows you to edit the following settings (see Figure 5.2):

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 98 99

Keine Kommentare

Wavetronix SmartSensor 105 (SS-105) - User Guide Bedienungsanleitung Seite 51