Wavetronix SmartSensor 105 (SS-105) - User Guide Bedienungsanleitung PDF herunterladen (Seite 71)

70 CHAPTER 6  LANE SETUP

hour (mph) or kilometers per hour (kph). e class indicates into which one of three

length-based classication groupings (0=Small, 1=Medium, and 2=Large) the vehicle

ts. e count is the time the vehicle entered the detection zone encoded as the num-

ber of 2.5ms ticks counted on the sensor since the beginning of the day (UTC time).

Note

Each time the Turn Event Logging On and O button is clicked, a new header is cre-

ated in the log ﬁle.

 Actuation/Event Toggle – Changes between Actuation and Event modes. Clicking on

the icon when an “A” is displayed changes the mode from Event to Actuation. Clicking

on the icon when an “E” is displayed changes the mode from Actuation to Event mode.

In Actuation mode, the three leftmost icons are inactive, and the vehicles are displayed as

long as they are present in the detection zone.

Interval Data

is screen allows you to verify interval data accuracy. e most recent interval data is dis-

played on the screen (see Figure 6.11). In order to keep a record of your verication results,

the interval data can also be saved to a log le while you remain on this screen.

Figure 6.11 – View Interval Data

Before interval data verication is performed, do the following:

1 Specify the desired interval length in the Interval (Bin) Size edit box. To do this,

enable the edit box by clicking Edit, then type the desired length of the interval in

seconds and click Submit. e minimum interval allowed is ve seconds. If you must

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 98 99

Keine Kommentare

Wavetronix SmartSensor 105 (SS-105) - User Guide Bedienungsanleitung Seite 71