Wavetronix SmartSensor Advance Extended Range (SS-200E) - Use Bedienungsanleitung PDF herunterladen (Seite 19)

18 CHAPTER 1  INSTALLING THE SMARTSENSOR ADVANCE

Figure 1.3 – Attaching the Mount Bracket to the Pole

4 Using the swivel joints (see Figure 1.4), pan and tilt the mount so that the mount head

points roughly to target distance in the center of the lanes of interest. (e viewnder

will be used later to help you achieve a more precise alignment.)

If the sensor is on a vertical pole, rst use swivel joint 1 to pan, then use swivel joint 2

to tilt. If the sensor is on a horizontal pole, rst use swivel joint 1 to tilt then use swivel

joint 2 to pan.

Figure 1.4 – Swivel Joints

Attaching the Sensor to the Mount Bracket

1 Align the bolts on the sensor’s backplate with the holes in the mount bracket. e 8-pin

connector on the sensor should be pointing towards the ground.

2 Place the lock washers onto the bolts aer the bolts are in the mount bracket holes.

3 read on the nuts and tighten (see Figure 1.5).

Figure 1.5 – Attaching the Sensor to the Mount Bracket

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 147 148

Keine Kommentare

Wavetronix SmartSensor Advance Extended Range (SS-200E) - Use Bedienungsanleitung Seite 19