Wavetronix Command Translator (CMD-DT) - User Guide Bedienungsanleitung PDF herunterladen (Seite 23)

22 CHAPTER 2  JOB LIST PAGE

Note

Storing too many history entries will result in poor performance; the recommended

number of entries is 10–100. This can be adjusted based on the number of deﬁned

jobs and how often they execute. If all entries need to be retained, a recommended

solution would then be to add an email notiﬁcation for oine management and

archiving.

 e Execution list gives the status and start/completion times for each individual ex-

ecution. is list will only appear if you are conguring a job (i.e. you accessed this

screen by clicking on the name of a job on the Job List); if you are adding a new job,

this area will be blank. Clicking on an execution time populates the Details text area

below the table.

 e Details text area displays specic information pertaining to each task and action

that was executed. is includes start and end times for each task, along with result

and error information, if appropriate. e text area is populated when you click on an

execution time in the Execution list.

Note

In cases where the job has been run multiple times due to an initial failure, the

results of each attempt will be listed in the Details text area, one after another. The

status icon will show “success” if any of the retry attempts succeeded; otherwise,

the icon will show “failure.”

Tasks

Click on the Tasks button to access the Tasks section (see Figure 2.7). is section allows

you to select and congure tasks to be executed with the current job.

Note

A task will not run automatically unless an event is added to trigger the job.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 155 156

Keine Kommentare

Wavetronix Command Translator (CMD-DT) - User Guide Bedienungsanleitung Seite 23