Wavetronix Command Translator (CMD-DT) - User Guide Bedienungsanleitung PDF herunterladen (Seite 44)

CHAPTER 4  ROUTES PAGE 43

Select either, both, or none of these options, then hit OK. More information about recali-

brating segments can be found later in this chapter.

Note

It is recommended that you manually validate the segments and mappings created

using this feature.

Zoom Options

In many cases, the number of segments in a route will be too many or too narrow to ef-

fectively view all useful information over the entire route. In these cases, the UI supports

zooming into smaller sections of the route. e zoom controls are located in the upper right

of the Edit Route page (see Figure 4.6).

Figure 4.6 – Zoom Options

To zoom in, enter mile marker values into the From and To elds representing the mile

markers to display at the far le and far right of the new display respectively. (e From and

To values must be between or equal to the start and end mile markers for the route.

Once you’ve zoomed in on a route, segments can still be selected and edited (although not

all segments in the route may be visible). In cases where segments extend beyond the zoom

boundaries in either direction, the segments lengths will have a “...” appended to the begin-

ning or end of their length display text to show that the segment continues on beyond the

border of the route graphic.

To return to the full view of the route—cancelling any zoom settings—push the Full View

button within the Zoom Options box.

Route

e primary route denition is displayed as a graphic showing the full length of the route

from the start mile marker to the end mile marker. Figure 4.7 shows a basic route 20 miles

long from MM #1 to MM #21.

Figure 4.7 – Basic Route

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 155 156

Keine Kommentare

Wavetronix Command Translator (CMD-DT) - User Guide Bedienungsanleitung Seite 44